April 2024

Be sure to bookmark mbox.fyi for quick access to Maker Box reveal posts.
Filamentcolors.xyz is a digital catalog of filament from around the globe, curated with the purpose of helping people find the perfect colors for their project. We print and photograph every filament under the same conditions, allowing users to compare different colors directly. We also measure the color and report this as a hex color, and use that to calculate complementary colors, similar filaments, and even similar colors in other materials to help users perfectly plan their projects. We’re a hobby project and always growing through filament donations and partnerships, so keep checking back to find your favorite filaments!

SWAG & CODES

  • Mini Cookies
  • Trading Cards

Please login to view codes if you received this months UFO.

Image
Subscriber @tsiolkovsky created a neat trading card holder for the top of the printer to hold the card for the sample you're printing with!
Download Card Holder

PLA

Accessory

Digital Calipers

Digital Calipers have a lot of uses both in 3D Printing and out.

NOTE: THE BATTERIES ARE IN THE PROJECT BAG

View on Amazon

Project

+Nano version of the Maker Box received an ESP32-WROOM

Coin Sorter/Counter

Files on Printables
Arduino Code

I thought this would be a fun project as the only other time IR sensors have been used is with the line following robot.

A couple notes:

  1. While planning out this project I miscalculated how many wires would be needed, I included 20 but realistically it needs 24 - =(
  2. It could really use a reset button... something I didn't think about when planning it out.
  3. As of this writing I haven't been able to figure out a good way to debounce the sensors - sometimes it will read more than 1 coin when only 1 coin passes because it reads too quickly >.< - working on it still but code is functional.
  4. I MAY relocate the sensors in the future if time permits. I just think they may work better under the track rather than in the tubes.

Included:

  • 4 x IR Sensor Modules
  • 128x32 OLED SCREEN
  • Stepper Motor
  • Stepper Motor Driver
  • Mini Breadboard
  • 10 x M3 Bolts
  • 10 x F to M Jumpers
  • 10 x F to F Jumpers

Pinout:

Motor:
+ from Driver to VIN of Control Board
- from Driver to GND of Control Board
IN1 from Driver to D27 on Control Board
IN2 from Driver to D14 on Control Board
IN3 from Driver to D12 on Control Board
IN4 from Driver to D13 on Control Board

OLED:
VCC to Pin D26 on Control Board
GND to GND on Control Board
SDA to Pin D21 on Control Board
SCL to Pin D22 on Control Board

Mini Breadboard:
The way the breadboard fits into the case, rows are shared connections.
3.3v from Control Board to top row of Breadboard
GND from Control Board to bottom row of Breadboard

IR Sensors:
All VCC goes to the top row of the Breadboard
All GND goes to the bottom row of the Breadboard
Quarter Out to Pin D15 on the Control Board
Nickel Out to Pin D4 on the Control Board
Penny Out to Pin D16 on the Control Board
Dime Out to Pin D17 on the Control Board

For some reason D2 wasn't working with the sensor so I skipped it, but tried to put all the pins on the same row and next to each other.

After everything is hooked up and programmed and powered on, the sensor boards will probably be reading HIGH as if it is detecting something. There is a potentiometer on the boards, rotate them counter clockwise until the right LED turns off (when looking at it from the sensors towards the pins)

Comments 1

Leave a Reply

Your email address will not be published. Required fields are marked *